WASHING MACHINE · UNION CITY
Washing Machine not draining in Union City? We fix it.
A washer that fills and washes but leaves a tub of standing water is one of the most common calls we run. The water has to go somewhere, and when it does not, the fault is almost always in the pump, the filter, or the drain path.
We handle washing machine not draining repairs across Union City, from Alvarado, Decoto, Mission Hills to the surrounding neighborhoods.
We cover Union City from our San Ramon base (South Bay). Here is the short version; the full guide is on the Washing Machine Not Draining page.
- $99 diagnostic (credited toward the repair)
- Same or next-day best effort
- CSLB #1136642
Why this happens
What we look for first.
- Clogged pump filter or coin trap. Front-loaders from Whirlpool, LG, Samsung, Bosch and Electrolux have a drain pump filter behind a small access panel at the bottom front. It catches coins, hair pins, bra wires and lint. When it packs up, the pump cannot pull water through and the cycle stalls with a full tub. We open the trap, clear it, and check the impeller behind it for damage. This is the first thing we look at and often the whole fix.
- Failed drain pump motor. The drain pump itself runs off a small motor that burns out, seizes, or loses a winding. You will often hear it hum or buzz without moving water, or hear nothing at all. We test the pump for resistance and check for 120V at the connector during the drain step. If the motor is dead and the windings read open, the pump gets replaced as a unit. Common on high-cycle households.
Full causes and diagnostic steps: Washing Machine Not Draining.
Serving Union City
Union City: response and coverage.
Union City is a 25 to 30 minute run down 680. We schedule it with the Fremont and Newark leg, so it runs on planned South Bay days, usually same-week.
Neighborhoods we cover regularly in Union City: Alvarado, Decoto, Mission Hills. Beyond those, our service area in Union City covers the city limits.
Union City is mid-century and 1980s tract housing through Alvarado, Decoto, and the Union Landing side, running GE, LG, Samsung, Whirlpool, and Maytag. The Mission Hills neighborhood above 880 is newer and pricier, adding Bosch and KitchenAid built-in.
Pricing and warranty
What it costs. What we stand behind.
-
$99
Diagnostic visit. Credited toward the repair.
-
Typical
Repair pricing is provided in a written estimate after the $99 on-site diagnosis, which is credited toward the repair.
-
Warranty
You get a parts and labor warranty in writing before we start: from 3 months to 2 years depending on the type of repair. Standard repairs carry 3 months on parts and labor, inverter boards 1 year, and a full sealed-system rebuild 2 years. We put the part, the price, and the labor on the quote before we touch the machine, so you know exactly what is covered.
Before you call
Is your washer or dryer worth repairing?
Repair price depends on the fault and access, especially on stacked units. If the machine cost under $1,000 new, the repair math may not work. We diagnose the machine on site and provide the written repair estimate before any work starts.
Under $1,000 new, repair may not be the right investment. Premium, stacked, and commercial-grade machines are stronger repair candidates, and we will give you a straight recommendation after diagnosis.
Worth checking yourself first: clear the lint trap and the vent path, make sure the load is not overloaded or sitting unbalanced, and look for a kink or clog in the drain hose. If the machine truly is done, put that money toward the replacement. And since we also run an HVAC side of the business, a free assessment visit comes with any furnace, A/C, or heat pump replacement.
Related
More on Washer and Dryer Repair and Union City.
Ready to book the Union City call?