MAYTAG DRYER · MILLBRAE
Maytag dryer not heating in Millbrae? We fix it.
Maytag dryers that tumble fine but dry cold are one of our bread-and-butter calls. These are Whirlpool-built machines, so the no-heat failures follow a tight pattern and we know where to look first.
We handle Maytag dryer not heating repairs across Millbrae, from Broadway corridor, Green Hills, Meadows to the surrounding neighborhoods.
We cover Millbrae with our San Mateo County technician (Mid-Peninsula). Here is the short version; the full guide is on the Maytag Dryer Not Heating page.
- $99 diagnostic (credited toward the repair)
- Same or next-day best effort
- CSLB #1136642
Why this happens
What we look for first.
- Blown thermal fuse. This is the most common no-heat cause on Maytag Bravos and Centennial units. The thermal fuse sits on the blower housing or near the heating element and is a one-time safety device. When the dryer overheats, usually from a clogged vent, the fuse opens and kills the heat circuit. The drum still turns because the motor runs on a separate path. We test it with a meter, replace it, and then find out WHY it blew so it does not happen again next month.
- Burned-out heating element (electric models). The coil element on electric Bravos and Centennial dryers sags and shorts to the metal housing or just breaks open with age. A broken coil reads open on the meter and gives you zero heat. A shorted coil can throw a breaker or heat constantly. We pull the element, ohm it out, and check for sag against the housing before deciding to swap it.
Full causes and diagnostic steps: Maytag Dryer Not Heating.
Serving Millbrae
Millbrae: response and coverage.
Millbrae is close to our San Mateo base, and our Peninsula technician works it regularly along with the rest of the BART and Caltrain corridor. We book by appointment rather than promising same-day arrival.
Neighborhoods we cover regularly in Millbrae: Broadway corridor, Green Hills, Meadows. Beyond those, our service area in Millbrae covers the city limits.
Millbrae kitchens run everyday brands, GE, Whirlpool, Samsung, LG, and KitchenAid, in the mid-century ranch homes near Broadway and the denser condo and townhome stock closer to the BART and Caltrain hub.
Pricing and warranty
What it costs. What we stand behind.
-
$99
Diagnostic visit. Credited toward the repair.
-
Typical
Repair pricing is provided in a written estimate after the $99 on-site diagnosis, which is credited toward the repair.
-
Warranty
You get a parts and labor warranty in writing before we start: from 3 months to 2 years depending on the type of repair. Standard repairs carry 3 months on parts and labor, inverter boards 1 year, and a full sealed-system rebuild 2 years. We put the part, the price, and the labor on the quote before we touch the machine, so you know exactly what is covered.
Before you call
Is your washer or dryer worth repairing?
Repair price depends on the fault and access, especially on stacked units. If the machine cost under $1,000 new, the repair math may not work. We diagnose the machine on site and provide the written repair estimate before any work starts.
Under $1,000 new, repair may not be the right investment. Premium, stacked, and commercial-grade machines are stronger repair candidates, and we will give you a straight recommendation after diagnosis.
Worth checking yourself first: clear the lint trap and the vent path, make sure the load is not overloaded or sitting unbalanced, and look for a kink or clog in the drain hose. If the machine truly is done, put that money toward the replacement. And since we also run an HVAC side of the business, a free assessment visit comes with any furnace, A/C, or heat pump replacement.
Related
More on Maytag and Millbrae.
Nearby cities
Maytag dryer not heating near Millbrae.
Also in Millbrae
Other dryer repairs we do in Millbrae.
Ready to book the Millbrae call?