How quickly can you reach Portola Valley for a Dacor service call?

Around 50 to 60 minutes from San Ramon via I-680 south and CA-92 or I-280. Portola Valley runs on the same Peninsula day as Hillsborough and Woodside, and we can usually offer same or next-day work with a written arrival time.

Do you carry common Dacor parts for the typical units in Portola Valley?

We keep oven sensors, bake and broil igniters, and common elements on the truck. ERC control boards and induction generator boards we source per call, and Samsung's ownership has kept that pipeline faster than it used to be under the old ownership.

What is the typical cost for a Dacor oven control or igniter call in Portola Valley?

Diagnostic runs $99, credited toward the repair. We provide a written repair estimate after the on-site diagnosis and before any work starts. You'll see a written quote before anything starts.

DACOR · PORTOLA VALLEY

Service · All Dacor Models

Dacor Cooking Appliance Repair · Portola Valley, CA

Dacor Heritage wall oven, dual-fuel and pro range, and Renaissance induction range service for Portola Valley.

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Dacor in Portola Valley

Dacor in Portola Valley kitchens.

Portola Valley's mid-century modern houses in the pockets near Ladera carry a fair number of Dacor Renaissance and Heritage ovens, a brand that fit the architecture when these homes were built and has stuck around since. The larger custom homes on wooded acreage off Alpine Road pair a Dacor wall oven with a separate range more often than not.

Oven ERC control-board faults and calibration drift show up here past the eight or nine year mark same as anywhere, though PG&E's public-safety power shutoffs add their own wrinkle: a hard power cut mid-bake can trip a fault code that looks like a board failure but clears once we reset and retest. From San Ramon that drive runs about 50 to 60 minutes, I-680 south into CA-92 or I-280.

Water and ice systems

The water inlet valve, a common fridge leak.

Every fridge with a dispenser or ice maker has a water inlet valve. The fittings can leak under the cabinet, or the solenoid fails and the dispenser and ice maker stop getting water.

Common repairs we do

What we close on the truck.

Stored fault code locking up the control board. Dead display, no heat, or a fault that won't clear, sometimes triggered by a power shutoff mid-cycle rather than a true board failure. I only swap the board if the fault holds after a reset.
Temperature reading off from the set point. The sensor drifts out of calibration with age. I check it against actual oven temperature and recalibrate from there.
Igniter losing strength by year ten. Weak ignition, or none at all, shows up reliably around the tenth year. I test the igniter and the element and replace whichever one is bad.
RR30 fault code, or hinges going soft on an older door. An element-fault code on the induction range, or a door sagging and leaking air on an older mid-century unit that's had the same hinges since new. I replace the generator board or the hinge-and-gasket set depending on the cause.

Models we service

Dacor product lines.

Wall ovens (Heritage, Discovery, Renaissance, Distinctive)
Dual-fuel, gas, and pro ranges (HDER, HDPR, HIPR)
Renaissance induction ranges (RR30)
Cooktops and rangetops
Built-in and freestanding refrigeration
Dishwashers

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Dacor service in neighboring cities.

More cities

Dacor across our service area.

FAQ

Dacor in Portola Valley questions, answered.

How quickly can you reach Portola Valley for a Dacor service call?

Around 50 to 60 minutes from San Ramon via I-680 south and CA-92 or I-280. Portola Valley runs on the same Peninsula day as Hillsborough and Woodside, and we can usually offer same or next-day work with a written arrival time.
Do you carry common Dacor parts for the typical units in Portola Valley?

We keep oven sensors, bake and broil igniters, and common elements on the truck. ERC control boards and induction generator boards we source per call, and Samsung's ownership has kept that pipeline faster than it used to be under the old ownership.
What is the typical cost for a Dacor oven control or igniter call in Portola Valley?

Diagnostic runs $99, credited toward the repair. We provide a written repair estimate after the on-site diagnosis and before any work starts. You'll see a written quote before anything starts.

Need Dacor service in Portola Valley?

Tell us what is broken. We will quote it.