How quickly can you reach Woodside for a Dacor service call?

About 50 to 60 minutes from San Ramon via I-680 south and CA-92 or I-280. We run Woodside on the same Peninsula day as Hillsborough and Portola Valley, and same or next-day work is realistic once we have a window, with a written arrival time attached.

Do you carry common Dacor parts for the typical units in Woodside?

Oven sensors, bake and broil igniters, and common elements ride on the truck. ERC control boards and induction generator boards get sourced per call. Samsung's ownership of Dacor has made those parts easier to get than they used to be.

What is the typical cost for a Dacor oven control or igniter call in Woodside?

The diagnostic is $99, credited toward the repair. We provide a written repair estimate after the on-site diagnosis and before any work starts. Gas work is done under CSLB #1136642, and you get a written quote before we start.

DACOR · WOODSIDE

Service · All Dacor Models

Dacor Cooking Appliance Repair · Woodside, CA

Dacor Heritage wall oven, dual-fuel and pro range, and Renaissance induction range service for Woodside.

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Dacor in Woodside

Dacor in Woodside kitchens.

Woodside estate kitchens off Mountain Home Road and Kings Mountain Road often pair a Dacor Heritage wall oven with a panel-ready refrigeration column and a separate pro range, the kind of build-out that shows up when a custom home gets its kitchen redone but keeps Dacor for the ovens. Guest houses and pool houses on these properties sometimes carry a second Dacor wall oven for the second kitchen.

Oven ERC control-board faults and temperature calibration drift are what we see most on these units once they clear eight or nine years, same as anywhere, though a unit doing double duty in a guest house sees more idle time between uses, which can hide a slow drift longer before anyone notices. The drive up from San Ramon takes roughly 50 to 60 minutes on I-680 south into CA-92 or I-280.

Water and ice systems

The water inlet valve, a common fridge leak.

Every fridge with a dispenser or ice maker has a water inlet valve. The fittings can leak under the cabinet, or the solenoid fails and the dispenser and ice maker stop getting water.

Common repairs we do

What we close on the truck.

Control board holding a stored fault code. A dead display, a stuck fault code, or a no-heat call all trace back here. I test the board and swap it if it fails under load.
Oven baking off the set point. More noticeable on a guest house oven used only on weekends, since nobody catches a slow drift right away out there. I check the sensor and recalibrate against actual temperature.
Ignition weakening on a year-ten oven. By this age the igniter draws current but doesn't produce enough flame, or stops producing it at all. I test and swap whichever of the igniter or element has failed.
RR30 induction fault, or a door starting to sag. An element-fault code on the induction range, or a door that sags and lets the seal leak on a heavily used main-kitchen unit. I replace the generator board or the hinge and gasket, whichever is the cause.

Models we service

Dacor product lines.

Wall ovens (Heritage, Discovery, Renaissance, Distinctive)
Dual-fuel, gas, and pro ranges (HDER, HDPR, HIPR)
Renaissance induction ranges (RR30)
Cooktops and rangetops
Built-in and freestanding refrigeration
Dishwashers

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Dacor service in neighboring cities.

More cities

Dacor across our service area.

FAQ

Dacor in Woodside questions, answered.

How quickly can you reach Woodside for a Dacor service call?

About 50 to 60 minutes from San Ramon via I-680 south and CA-92 or I-280. We run Woodside on the same Peninsula day as Hillsborough and Portola Valley, and same or next-day work is realistic once we have a window, with a written arrival time attached.
Do you carry common Dacor parts for the typical units in Woodside?

Oven sensors, bake and broil igniters, and common elements ride on the truck. ERC control boards and induction generator boards get sourced per call. Samsung's ownership of Dacor has made those parts easier to get than they used to be.
What is the typical cost for a Dacor oven control or igniter call in Woodside?

The diagnostic is $99, credited toward the repair. We provide a written repair estimate after the on-site diagnosis and before any work starts. Gas work is done under CSLB #1136642, and you get a written quote before we start.

Need Dacor service in Woodside?

Tell us what is broken. We will quote it.