Fisher & Paykel Repair · Bay Area

Yes, we service Fisher & Paykel. Here’s the honest read for an owner, without the sales pitch.

The DishDrawer is the unit most people call about, and it fails in a few predictable spots. The lid actuator wears out around year five, and you get an F1 code with a drawer that won’t start. Dishes coming out wet on the top drawer is usually a dry rinse-aid reservoir or the drying fan, not a dead heater, so check the rinse aid before anyone buys a part. A drawer that goes dead mid-cycle is often the flood switch in the base tray tripped by a small leak, not the controller. These drawers keep a fault log, so we read it and run the test cycle instead of guessing. See the Fisher & Paykel dishwasher repair guide for the first-visit checks and pricing process.

On the fridges, the ActiveSmart French-door units get a loud, coming-and-going rattle from the fresh-food evaporator fan. We diagnose the fault on site, then provide a written repair estimate before any work starts. The column fridges (RS90, RS36) throw a comms fault where the fridge looks dead but the compressor’s running, usually a worn ribbon harness at the door hinge. Gas cooktops on the OB and CG series throw a flame-failure code when the thermocouple weakens, and we keep the common ones on the truck.

Repair or replace: parts move through the New Zealand supply chain, which has gotten reliable the last couple of years, so most Fisher & Paykel faults are worth fixing rather than tossing a good machine. The exception is an older DishDrawer stacking up two or three failures at once. We’ll tell you which one you’ve got.

The $99 diagnostic is credited toward the repair. After we’ve seen the fault you get a written repair-or-replace call and a price, never a number over the phone.

Schedule a visit