How long does it take you to reach Portola Valley from San Ramon?

Roughly 50 to 60 minutes via 680 south and then 92 or 280. Portola Valley runs on our Peninsula day alongside Hillsborough, so once a job is booked you get a written arrival time, not a guess.

The KitchenAid range bakes unevenly. Is that worth a service call?

Yes, and it is usually an easy fix. On the KFGC range that symptom points to the oven sensor or a calibration issue more often than the burners. We check actual cavity temperature against your setpoint before we recommend a part.

KITCHENAID · PORTOLA VALLEY

Service · All KitchenAid Models

KitchenAid Appliance Repair · Portola Valley, CA

KitchenAid repair for Portola Valley's guest units and secondary kitchens:

$99 diagnostic (credited toward the repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Straight answer

KitchenAid dishwashers we do not take.

KitchenAid dishwashers are not a repair we take. Not any model, any year.

It is not a knock on the machines. It is the parts pricing. What a circulation pump, a control board, or a touch panel costs on one of these, set against what the dishwasher sold for new, turns the repair into a bad buy for you more often than not. We would rather tell you that here than charge you $99 to say it in your kitchen.

Everything else from these brands we still fix: refrigerators, ranges, ovens, cooktops, washers, and dryers. We repair dishwashers from every other brand.

That answer does not change by town, so it holds in Portola Valley the same as anywhere else we run. Call us on the rest of the kitchen and we will be out.

Serviced: Fisher & Paykel, Miele, Cove, Asko. We also service every other residential and commercial brand.
Not serviced: LG, Samsung, Bosch, KitchenAid, Whirlpool, Jenn-Air dishwashers
Still serviced on those brands: refrigerators, ranges, ovens, cooktops, washers, dryers

KitchenAid in Portola Valley

KitchenAid in Portola Valley kitchens.

Most of the custom homes off Alpine Road and Portola Road run Sub-Zero or Wolf in the main kitchen, so a KitchenAid in Portola Valley usually lives in a guest unit or an older wing of the house, sometimes a mid-century remodel near Ladera that kept its original layout. The KFGC range and the KRFC built-in fridge are the models we see most.

The range complaint we hear most is uneven or hotter-than-set baking, and before we assume the oven is bad we probe the cavity and compare the real temperature to the setpoint, since a sensor or calibration issue is the more common cause. On the built-in fridge we start with the amp-draw and discharge-line reading rather than jumping to a sealed-system diagnosis, because that is what actually separates a compressor problem from a control issue. With power shutoffs common out here during fire season, we also ask whether the unit has been running off a generator, since rough power can trip a control board without damaging the compressor at all.

What the work looks like

A built-in sealed-system leak repair.

Nitrogen pressure and a soap-bubble test on a built-in fridge line set. We map every leak source before we braze.

The corroded copper up close. After fifteen-plus years this is why a real fix rebuilds the sealed run, so you do not pay the labor twice.

ADRIUM technician brazing a copper refrigerant line onto a compressor with a torch during a sealed-system repair — Brazing a new line onto the compressor during the same kind of sealed-system repair. Recover, braze, evacuate, and recharge: the real fix, done as one complete job.

Common repairs we do

What we close on the truck.

KFGC oven baking hot or uneven. The setpoint says one temperature and the food says another. Before swapping parts we put a probe in the cavity and log actual temperature against the dial, because a drifted sensor or a calibration problem is the usual cause, not a dead oven.
KRFC or KBFN built-in fridge not holding temperature. We start with an amp-draw reading and a discharge-line check, plus the manufacturer's diagnostic program, before deciding it is a sealed-system job. On homes running backup power during a PSPS event, a control fault is just as likely as a refrigerant problem.
KOSE wall oven with a dead bake element. No lower glow and a cold bake cycle while the broiler still works points straight at the element. Have the model number ready at booking and it is usually a common repair with a part we usually stock.

Models we service

KitchenAid product lines.

Built-in French-door refrigerators (KRFC, KBFN)
KFGC commercial-style ranges
KOSE wall ovens
Counter-depth side-by-side fridges

Pricing and warranty

What it costs. What we stand behind.

$99

Diagnostic visit. Credited toward the repair.
Written

3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Recent work

KitchenAid jobs we have closed.

See all case studies →

Nearby cities

KitchenAid service in neighboring cities.

More cities

KitchenAid across our service area.

FAQ

KitchenAid in Portola Valley questions, answered.

How long does it take you to reach Portola Valley from San Ramon?

Roughly 50 to 60 minutes via 680 south and then 92 or 280. Portola Valley runs on our Peninsula day alongside Hillsborough, so once a job is booked you get a written arrival time, not a guess.
The KitchenAid range bakes unevenly. Is that worth a service call?

Yes, and it is usually an easy fix. On the KFGC range that symptom points to the oven sensor or a calibration issue more often than the burners. We check actual cavity temperature against your setpoint before we recommend a part.

Need KitchenAid service in Portola Valley?

Tell us what is broken. We will quote it.