What is your travel time to Hillsborough from San Ramon?

About an hour via the San Mateo Bridge on Highway 92, a bit less midday. We schedule Hillsborough on Peninsula days together with Atherton, Palo Alto, and Los Altos Hills, so you get a committed window rather than an all-day wait.

My Speed Queen is from 2010. Should I fix it or replace it?

Bring us to look before you decide. These machines were built for fifteen to twenty years, and a 2010 mechanical model is often better made than what would replace it. If the diagnosis lands on a part that is discontinued or a stack of failures, I will say replace. Most of the time it is one part and the machine runs for years more.

Do you work in basements and tight service halls?

Yes, that is normal for Hillsborough. Let us know about stairs or narrow doorways when you book so we plan for it. We protect the floors on the way in and out, and most repairs happen in place without pulling the machine out of the room.

SPEED QUEEN · HILLSBOROUGH

Service · All Speed Queen Models

Speed Queen Laundry Repair · Hillsborough, CA

Speed Queen repair for Hillsborough's older homes, from a shop that respects old wiring.

$75 diagnostic (waived with repair)
Same or next-day best effort
CSLB #1136642

Call (925) 999-4095

Speed Queen in Hillsborough

Speed Queen in Hillsborough kitchens.

Hillsborough housing runs old. A lot of the homes we service were built between the twenties and the sixties, and the laundry often lives in a basement or a back service hall that was wired generations ago. When a Speed Queen dryer stops heating in Hillsborough, the machine is a suspect but so is the 240V circuit feeding it, and we test the outlet before we condemn any part.

The washers here skew toward the TC5 and the older Classic series machines that people refuse to give up, with good reason. A mechanically controlled Speed Queen from fifteen years back is still a serviceable machine, and I would rather rebuild one than watch it get replaced with something that lasts seven years.

We come over the San Mateo Bridge from San Ramon on our Peninsula route. Diagnostic is $75 and it is credited toward the repair, with every quote written before parts are ordered.

Common repairs we do

What we close on the truck.

Dryer heat gone, and the outlet is part of the diagnosis. On Hillsborough's older circuits we see dryers that lost one leg of their 240V supply, which kills the heat while the drum keeps turning. It looks exactly like a failed element. We test the receptacle first, then the element and both thermostats on the DR series. If the problem is upstream in the house wiring, we tell you that instead of selling a part that will not fix it.
Oil spotting under an older TC or Classic washer. A slow transmission seal weep on an aging Speed Queen top-loader leaves a small dark spot on the basement floor. It can run for years, or it can accelerate. At the diagnostic I check the oil level behavior and the seal condition and give you a straight answer on whether it is a watch item or a repair-now item, with the cost of each path in writing.
Cold fill that takes forever. Peninsula water plus decades of galvanized supply pipe in an older home means sediment, and the inlet valve screens on a Speed Queen catch all of it. Slow fill, weak rinse, or wrong water temperature all trace back to that valve. We replace it rather than clean it, because a valve that has run restricted tends to fail closed or start dripping soon after.

Models we service

Speed Queen product lines.

TC and TR top-load washers
FF front-load washers
DC and DR dryers
Commercial-grade residential laundry

Pricing and warranty

What it costs. What we stand behind.

$75

Diagnostic visit. Waived when you book the repair with us.
Written

90 days on consumables, 1 year on major parts, 2 years on sealed-system rebuilds. Quoted in writing before work starts.
CSLB

#1136642. Bonded and insured. We file warranty paperwork when applicable.

Nearby cities

Speed Queen service in neighboring cities.

More cities

Speed Queen across our service area.

FAQ

Speed Queen in Hillsborough questions, answered.

What is your travel time to Hillsborough from San Ramon?

About an hour via the San Mateo Bridge on Highway 92, a bit less midday. We schedule Hillsborough on Peninsula days together with Atherton, Palo Alto, and Los Altos Hills, so you get a committed window rather than an all-day wait.
My Speed Queen is from 2010. Should I fix it or replace it?

Bring us to look before you decide. These machines were built for fifteen to twenty years, and a 2010 mechanical model is often better made than what would replace it. If the diagnosis lands on a part that is discontinued or a stack of failures, I will say replace. Most of the time it is one part and the machine runs for years more.
Do you work in basements and tight service halls?

Yes, that is normal for Hillsborough. Let us know about stairs or narrow doorways when you book so we plan for it. We protect the floors on the way in and out, and most repairs happen in place without pulling the machine out of the room.

Need Speed Queen service in Hillsborough?

Tell us what is broken. We will quote it.