GE · HALF MOON BAY
Service · All GE ModelsGE Appliance Repair · Half Moon Bay, CA
GE repair for Half Moon Bay and the Coastside, Montara to El Granada. 94019.
- $99 diagnostic (credited toward the repair)
- Same or next-day best effort
- CSLB #1136642
GE in Half Moon Bay
GE in Half Moon Bay kitchens.
Half Moon Bay is the anchor for the whole Coastside, and our route runs the same out to Montara, Moss Beach, and El Granada, not just the town around Main Street and the harbor. The salt air off the water is what makes GE service calls out here a little different from the inland Peninsula towns. Salt air corrosion shows up on the parts you'd expect, water inlet valves, icemaker fill lines, the fasteners on a range hood, and it moves faster on a house two streets from the bluff than one set further back. I check corrosion on connections as part of the diagnostic even when the reported problem is something else, because a corroded valve is often the real cause of a leak someone blamed on the appliance itself.
We're ADRIUM Service Solutions, family owned, based in San Ramon, and the technician who covers the Coastside lives on the Peninsula, so Half Moon Bay, Montara, Moss Beach, and El Granada all get the same local response. Diagnostic is $99, credited toward the repair, quotes are written, seven days a week. CSLB #1136642, EPA 608 certified.
Water and ice systems
The water inlet valve, a common fridge leak.
Common repairs we do
What we close on the truck.
- Refrigerator icemaker water line corroded or frozen. Salt air speeds up corrosion on the fill valve and the line fittings behind the fridge. A slow leak or a dead icemaker often traces back there instead of the icemaker module itself.
- Range hood and oven exterior hardware rusting early. Screws, hinges, and trim corrode faster this close to the water. I replace what's already failed and flag anything else headed that direction so it doesn't turn into a second call.
- Dishwasher rack coating wearing through. Salt air and the coastal humidity together speed up rack wear, which shows up as rust spots and eventually exposed wire. I check the racks on every Coastside dishwasher call, even when that's not why you called.
- Profile refrigerator defrost-cycle heater fails. Even out here the most common Profile failure is still the defrost heater. Frost builds on the coil until the fresh food side runs warm. I check the heater and the fill valve fittings on the same visit since salt air tends to hit both around the same age.
Models we service
GE product lines.
- Monogram luxury built-ins
- Cafe Series with brass accents
- Profile mid-tier
- Adora entry
- Energy Star certified lines
Pricing and warranty
What it costs. What we stand behind.
-
$99
Diagnostic visit. Credited toward the repair.
-
Written
3 months standard, 1 year on inverter boards, up to 2 years on sealed-system rebuilds. Quoted in writing before work starts.
-
CSLB
#1136642. Bonded and insured. We file warranty paperwork when applicable.
Recent work
GE jobs we have closed.
-
GE French Door Refrigerator Freezer Icing Up and Ice Maker Over-Icing
A GE french door refrigerator in Millbrae was icing up from the inside: the ice maker was freezing over, frost had spread across the back wall of the freezer and the air vent housing, and ice was building up on the freezer drawer rails.
Read case → -
GE Monogram Built-in Fridge Not Cooling: Sealed-System Rebuild, San Ramon
A San Ramon GE Monogram built-in fridge had stopped cooling. Both compartments warming, the unit running non-stop, ice building up, and a loud compressor.
Read case → -
GE Monogram Double Oven Shutting Down: Cooling Fan Motor
A Walnut Creek GE Monogram double oven kept overheating and shutting itself off, with a cooling-related error on the panel.
Read case →
Nearby cities
GE service in neighboring cities.
More cities
GE across our service area.
- GE in Alameda
- GE in Alamo
- GE in Berkeley
- GE in Blackhawk
- GE in Castro Valley
- GE in Concord
- GE in Cupertino
- GE in Danville
- GE in Dublin
- GE in Fremont
- GE in Hayward
- GE in Lafayette
- GE in Livermore
- GE in Los Altos
- GE in Los Gatos
- GE in Martinez
- GE in Menlo Park
- GE in Milpitas
- GE in Mountain View
- GE in Newark
- GE in Oakland
- GE in Orinda
- GE in Palo Alto
- GE in Pleasant Hill
- GE in Pleasanton
- GE in Richmond
- GE in San Jose
- GE in San Leandro
- GE in San Ramon
- GE in Santa Clara
- GE in Sunnyvale
- GE in Union City
- GE in Walnut Creek
- GE in Atherton
- GE in Hillsborough
- GE in Los Altos Hills
- GE in Moraga
- GE in Piedmont
- GE in Saratoga
- GE in Albany
- GE in El Cerrito
- GE in Woodside
- GE in Portola Valley
- GE in Daly City
- GE in South San Francisco
- GE in San Bruno
- GE in Foster City
- GE in Belmont
- GE in San Carlos
- GE in Redwood City
- GE in East Palo Alto
- GE in Millbrae
FAQ
GE in Half Moon Bay questions, answered.
-
Do you cover Montara, Moss Beach, and El Granada too, or just Half Moon Bay itself?
All of it. Half Moon Bay is the anchor of the route, and Montara, Moss Beach, and El Granada get the same technician and the same response. -
Does the salt air really affect appliance repairs out here?
Yes, more than people expect. Water valves, fittings, and exterior hardware corrode faster this close to the ocean. I look for it during every diagnostic, not just when someone mentions rust. -
How quick is your response time to the Coastside?
The technician on this route is Peninsula based, in San Mateo County, so Half Moon Bay and the surrounding Coastside towns aren't an afterthought tacked onto a San Ramon schedule. The same route runs the Highway 92 corridor back toward San Mateo and Burlingame.
Need GE service in Half Moon Bay?